www.hyundailighting.com.au
Licensed by HYUNDAI Corporation Holdings, Korea
Imported/Distributed by Azoogi Pty Ltd
Before the installation, please ensure the power is off.
Ensure that surface is clean and dry prior to
applying LED Strip. It is recommended to use
rubbing alcohol and not any household cleaners
or water.
Peel off the double-sided tape and apply to the
surface. Carefully consider placement of the
product due to strong adhesive qualities.
Plug power adaptor into power point.
To control the Smart RGBW LED Strip, you can
use Smart Life – Smart Living app on your phone
or tablet or alternatively use the remote control
(refer to the following sections for details).
To start using the RF remote, pull the insulation
strip and make sure the remote is pointed in the
line of sight to all the receivers.
Installation
1
2
3
4
5
If the LED strip is longer than what you need, you can cut
the LED strip to your desired length. However, note that
you can cut the strip only at intervals where the “scissor”
symbols are provided (see example in the following image).
You must not cut the LED strip from the power end as it
would cut off the supply of power to the strip.
Attach the strip to the controller
using it’s 5-pin connector and
make sure that the arrows
are pointing at each other as
shown in the image below.
Subsequently, attach the DC
jack to the adapter. You may
then plug the adapter into the
outlet and switch it on.
Cutting the strip
Powering the strip
NOTE:
Do not sharply bend or twist the LED strip. The strip
can only be bent in the gaps between the components.
Smart RGBW LED Strip Installation Manual
