Detection range [ ]
Press buttons in zone to set detection range at 100% / 50% / 10%.
Hold time [ ]
Press buttons in zone to set hold time at 30s / 1min / 5min / 10min / 30min.
Stand-by period [ ]
Press buttons in zone to set stand-by period at 0s / 10s / 1min / 10min / 30min / +
∞
.
Note: “0s” means on/off control; “+∞
” means bi-leve of dimming control, light never switches off.
Stand-by dimming level [ ]
Press buttons in zone to set the stand-by dimming level at 10% / 20% / 30% .
Daylight sensor [ ]
Press buttons in zone to set daylight sensor at 2lux / 10lux / 50lux.
6
11
13
12
7
M/A [ ]
Note: this button is disabled.
button
15
zone
6
zone
11
zone
12
zone
7
zone
13
SECTION 3 REMOTE CONTROL
Permanent ON/OFF [ ]
1. Press button , the light goes to permanent ON or permanent OFF mode.
2. Press button to quit from this mode.
3. The mode will change to AUTO Mode after power failure.
(Please refer to explanation accordingly)
Auto Mode [ ]
Press button goes to auto mode, the sensor starts working and all settings remain the same as the latest status before the light was switched ON/OFF.
RESET [ ]
Press button , all settings go back to the value of rotary switch.
Test 2s function [ ]
1. Press button , the sensor goes to test mode (hold time 2s), stand-by period and daylight sensor are disabled.
2. Press button to quit from this mode, and the sensor setting is changed accordingly.
Ambient daylight threshold [ ]
Press button , the latest surrounding lux value overwrites previous lux value learend, and is set as the daylight threshold. This feature enables the fixture
to function well in any real application circumstance.
1
2
3
2 3 4
button
1
button
2
button
3
8
3
10
4 11
button
8
button
10
Power output [ ]
Press button , the output shifts between 80% (at initial 10,000 hours) and 100%, for energy saving purpose.
5
button
5
Dim +/- [ ]
Press button to adjust the light brightness between 10%~100% during hold-time.“+” means dimming up, “-” means dimming down.
9
button
9
Lux disable [ ]
Press button , the built-in daylight sensor stops working, and all motion detected could turn on the lighting fixture, no matter how bright the natural light is.
14
button
14
5
9
4
11
12
Stand-by dimming level
Detection range
ON/
OFF
Auto Mode
Reset
Power
80%
Test
2s
10%
20%
30s
1min
100%
30min
10min
5min
0s
10s
1min
30%
SC1
SC2
SC3
Scene mode
10min
50%
10%
30min
Hold-time
Stand-by period
5min
Lux
Disable
2Lux
10Lux
50Lux
Daylight Sensor
SC4
Power
100%
+
-
Dim
M/A
3
1
2
7
8
6
10
13
14
15
HRC-05
Note: the buzzer beeps one time when RC
receives signal successfully
