HYT TC-500, Руководство по обслуживанию, Страница: 6 / 77

TC-500 Service Manual
5
Software Specification
Radio Feature Description
1. Use Channel Selector Knob to choose from 15+1(Scan) channels
2. Monitor
3. CTCSS/CDCSS
Non-standard Model (Other): 38+83 groups
4. Channel Spacing
12.5KHz/25KHz Narrow/Wide Selectable
5. Channel Scan (Priority channel and scan revert channel available)
6. Battery Save Feature (the function can be programmed by dealer as on/off)
7. Time-out Timer (TOT)
8. High/low Power Switch
9. Squelch Level Control (9 levels)
10. Low Battery Alert
11. Model Set Mode
12. PC Programming and Adjusting Mode
13. User Wired Clone Mode
14. Factory Wired Clone Mode
15. Manual Adjust Mode
Radio Modes
User Mode
User mode is conventional communication mode. Turn the power on while disconnecting the two SELF
points, the radio enters user mode. (Refer to “TC-500 Owner’s Manual”for details about operation in this
mode.)
Model Set Mode
1. If the radio is in standard model, short out the two MS2 points on PCB and then operate following the
steps (3), (5) and (6). If the radio is in non-standard model, please disconnect the two MS2 points on
PCB and then operate the following steps.
2. To select MS1 (See the initial data table) according to the radio model, if MS1 is 1, short out the two
MS1 points on PCB and continue the following operation. If not, disconnect the two MS1 points and
continue.
3. Short out the two SELF points on PCB and then turn the power on. Two beeps sound.
4. Turn Channel Selector Knob to the corresponding position (1-11) according to the radio model (Refer
to the initial data table).
5. Press PTT key while holding down MONI key to set the model. Channel data and settings are
initialized (Refer to the initial data table).