Two-Stage Mast Assembly
4000 SRM 482
6.
Install a sling and crane to support the cylinder.
Remove the lift cylinder retainer, capscrews, and
washers.
7.
Push the cylinder toward the top of the mast as-
sembly to move the lift cylinder off the locating
dowel pin. Continue to push the cylinder so that
the rod moves into the cylinder to allow removal
from the inner weldment.
8.
Repeat Step 2 through Step 7 to remove the other
lift cylinder.
NOTE:
See the section Lift Cylinders 4000 SRM 481
to disassemble and repair the cylinder.
9.
Reverse the procedure to install the lift cylinders.
LIFT CYLINDER, REMOVE AND INSTALL
SINGLE MAIN-LIFT CYLINDERS
For the following instructions, refer to Figure 13 and
Figure 14.
Figure 13. Lift Chains and Sheaves, Single-Lift
Cylinder
Legend for Figure 13
1.
SNAP RING
2.
CAPSCREW AND LOCKWASHER
3.
SUPPORT BRACKET
4.
SHAFT
5.
SPACER
6.
SHEAVE
7.
BALL BEARING
8.
RETAINING RING
9.
WASHER
10. LIFT CHAIN
11. COTTER PIN
12. PIN
13. CHAIN ANCHOR
14. NUT
15. LOCKWASHER
16. PIN
17. CHAIN ANCHOR
18. SNAP RING
19. LUBE FITTING
20. COTTER PIN
Figure 14. Two-Stage Single-Lift Cylinder -
Hydraulic Connections
14
Содержание MAST N30XMH
