9.
Disconnect the brake line from the piston
chamber and drain oil into a suitable container.
See Figure 4.
1. BRAKE LINE
Figure 4. Brake Line and Piston Chamber
10.
Place blocks under the axle assembly and con-
nect slings and lifting device.
11.
Place blocks under the transmission to support
the transmission while removing the drive axle.
12.
Remove the capscrews holding the drive shaft
and remove the drive shaft.
13.
Remove the transmission isolator mounting
bolt located on top of the assembly. See Fig-
ure 5.
14.
Remove the four mounting capscrews and
washers from the drive axle. See Figure 6.
15.
Remove blocks and lower the drive axle assem-
bly. Pull axle forward and away from frame.
16.
Place blocks under the differential assembly.
NOTE:
DRIVE AXLE FOR H4.0FT5/FT6; H4.5FTS5,
H4.5FT6, H5.0-5.5FT (H80, 90, 100, 110, 120FT)
(R005, S005, U005) SHOWN. TRANSMISSION
MOUNTING FOR S4.0, 4.5, 5.5FT, S5.5FTS (S80,
100,
120FT;
S80,
100FTBCS;
S120FTS;
S120FTPRS) (H004, J004) IS SIMILAR.
1. ISOLATORS
2. WASHER
3. WASHER
4. CAPSCREW
5. TRANSMISSION
6. DRIVE AXLE
Figure 5. Transmission to Differential Mounting
Bolt
Drive Axle Removal
1400 SRM 1582
4
