Hyster E019, Руководство по обслуживанию и ремонту

Страница: 21 / 21

600 SRM 1068 Cylinder Head Assembly Repair
Install
Special Tools: Angle gauge to tighten the
capscrews for the cylinder head
1. Verify the surfaces of the cylinder head and the
top of the engine block are clean. Verify that
there is no dirt or objects in the cylinders.
2. Install the gasket for the cylinder head as shown
in Figure 15. Verify the TOP FRONT is in the
correct position. Do not use any gasket sealant
on any of the surfaces.
3. Use two 1/2 UNF studs in positions 25 and 30.
See Figure 16. Lower the cylinder head into po-
sition on the engine block. See Figure 17.
Figure 15. Head Gasket Position
Figure 16. Cylinder Head Tightening Sequence
Figure 17. Cylinder Head Installation
CAUTION
There are three lengths of capscrews. S = short,
M = medium, L = long. Figure 16 shows their po-
sitions in the engine. Verify that the capscrews
are installed in the correct positions.
4. Lubricate the capscrews with a thin coat of oil
and install them into their holes in the cylinder
head. When the cylinder head and gasket are
held in position, remove the two studs and install
the two capscrews in those positions.
5. Evenly tighten the capscrews in the sequence
shown in Figure 16. The final torque on the cap-
screws is 110 N•m (81 lbf ft).
11