2.
Apply a molybdenum grease or equivalent to
following valve rocker arm contact surfaces:
• Valve push rod socket
• Roller pivot
• Valve stem tip
1. VALVE PUSH ROD SOCKET
2. ROLLER PIVOT
3. VALVE STEM TIP
4. ROCKER ARM BOLT
Figure 11. Lubricate Valve Rocker Arm Surfaces
3.
Install valve rocker arm assemblies as follows:
a.
Finger start rocker arm bolt at location 1
in Figure 12.
b.
Finger start rocker arm bolt at location 2
in Figure 12.
c.
Finger start rocker arm bolt at location 3
in Figure 12.
d.
Finger start remaining three valve
rocker arm bolts.
Repeat for other side.
1. BOLT AT LOCATION 1
2. BOLT AT LOCATION 2
3. BOLT AT LOCATION 3
Figure 12. Install Valve Rocker Arm Assemblies
4.
Rotate crankshaft balancer to position crank-
shaft balancer alignment mark 57 to 63 degrees
clockwise or counterclockwise from engine front
cover alignment tab. See Figure 13.
0600 SRM 1251
Cylinder Head Repair
9
