ACCESSING THE DRIVE UNIT
COMPARTMENT
The drive unit compartment is concealed behind a molded
cover which fits securely around the drive unit and steer
support to the frame. The floor mat fits snugly in the
operator platform after the drive unit cover is installed.
To remove the drive unit cover, first lift the corners of the
floor mat and pull it out away from the drive unit. See
Figure 2. Next, reach under the side of the drive unit cover
near the bottom and find the grip slot. With both hands,
pull up and away from the truck until the bottom of the
cover kicks out from the retaining clips. See Figure 3.
Repeat this for the other side of the cover. Work around the
edge of the cover until it is freed from the truck.
1. FLOOR MAT
2. DRIVE UNIT COMPARTMENT COVER
3. FRAME
4. CASTER ADJUSTMENT ACCESS
Figure 2. Floor Mat
1. DRIVE UNIT COMPARTMENT COVER
2. RETAINING CLIPS
3. GRIP SLOT
4. FRAME
Figure 3. Drive Unit Compartment Cover
To install the drive unit cover, make sure the floor mat is
pulled away from the drive unit. Place the bottom of the
drive unit cover onto the operator platform and position the
lower edges partially into the lower retaining clips. Push
the top of the cover partially into the upper retaining clips.
Do not push either edge of the cover in completely before
starting all edges into the proper place. When the cover is
aligned and started properly, press the cover completely
into the retaining clips and place the floor mat into the
operator platform around the cover.
General
2200 SRM 1640
2