Power Connections
SPECIFICATION HYP2000.1D HYP1500.1D
DIMENSIONS HYP2000.1D HYP1500.1D
(HYP2000.1D, HYP1500.1D)
7.87” / 200mm
6.77” / 172mm
2” / 51mm
Dynamic Power
Signal to Noise Ratio
Low Pass Crossover
Bass Boost @ 45 Hz
Frequency Response
THD @ 1 %
Fuse Rating
Input Sensitivity
Class D Circuitry
1 Ohm Load Mono Capability
PWM Mosfet Power Supply
RCA Line Level Stereo Inputs
12dB Variable Low Pass Crossover
Variable Subsonic Filter
Variable Bass Boost @ 45 Hz
Thermal Protection Circuitry
Bass Remote Included
1500 Watts
1 x 750 Watts @ 2 Ω
1 x 1500 Watts @ 1 Ω
>90dB
40Hz-180Hz
0-12db
10Hz-180Hz
<0.1%
2 - 20A
100mV-6V
7.87” / 200mm
8.34” / 212mm
2” / 51mm
Width
Length
Height
2000 Watts
1 x 1000 Watts @ 2 Ω
1 x 2000 Watts @ 1 Ω
>90dB
40Hz-180Hz
0-12db
10Hz-180Hz
<0.1%
2 - 30A
100mV-6V
• 5 •
• 2 •
It is important that you read this manual very carefully and follow it for your installation carefully.
Before you start your installation,please consider following concerns.
1.Disconnect the negative (-) battery cable before mounting the ampl
r or making any connections .
Check the battery and alternator ground (-) connections. Make sure they are properly connected and
free of corrosion.
2.Before selecting a mounting location for ampl
r, please take some concerns into consideration
with cooling e
ency and safety.
3.Power connection
Before installing ampl
r,disconnect the negative (-) wire from battery to protect any accidental
damage to your ampli
and System.This Ampl
r is designed to use 4 Gauge POWER and GROUND
cables.
4.Ground connection
Locate a secure grounding connection as close to the ampli r as possible. Make sure the location is
clean and provides a direct electrical connection to the frame of the vehicle.Connect one end of a
short piece of the same size cables as the power cable to the grounding point.Run the other end
of the cable to the ampli
loc ation. Connecting the ground cable to the screw terminal
labeled as GND.
5.Remote connection
Run a remote turn on cable from the sw12V source you will be using to turn on the system
components. This may be a toggle switch, a relay, or your source unit`s remote trigger wire, or power
antenna trigger wire. Connect the remote turn on cable to the power terminal labeled as REM. Run
this lead to the ampli
16 Gauge wire or larger.
