10
Field Service Bulletin 807570 Revision 0
Gas Console manifold Replacement
3.
Remove the phillips head screw that secures the manifold to the bottom of the enclosure and slide the manifold out
far enough to access the screw that secures valve SV3.
Phillips head screw
4.
Loosen the phillips head screw that secures the connector to valve SV10 and remove the connector. Discard the old
manifold.
Phillips head screw
Install the new lower manifold
NOTE: refer to the pictures shown during the removal process when installing the new manifold
1.
Place the manifold about half way into the enclosure. Route the yellow hose between valve 4 and valve 5, and the red
hose between valve SV2 and SV8.
2.
Attach the connectors to valves SV1, SV2, SV8, and SV9
3.
Attach the connector to valve SV3.
4.
Connect the hoses to the manifold in the following order; the shorter yellow hose, the red hose, and the shorter black
hose.
5.
Reconnect the supply gas hoses and turn on the supply gases.
6.
Run the gas leak tests for the system. See your HPRXD instruction manual for details.