Hypertherm EcoSift, Руководство оператора

Страница: 76 / 188

Preventive maintenance
Preventive main
tenance
76 EcoSift Operator Manual 809500
Examine the waste hopper
Do this task when the EcoSift is operating.
1. Examine the hopper for leaks, deterioration, or damage.
Identify the source of a leak and correct the problem.
2. Examine the latch assembly for deterioration or damage. Lubricate the hinges and the pivot points with oil or
grease, if necessary.
3. Replace the waste-abrasive collection bag, if necessary.
Replace the waste-abrasive collection bag
If the bag is too full, particles of abrasive accumulate outside of the bag in the waste hopper and the hopper must
be cleaned. Refer to
Clean the waste hopper
on page 81.
This procedure requires 2 people for some tasks.
Repair or replace parts identified in the preventive maintenance schedule or if the parts are
defective, deteriorated, corroded, or damaged.
WARNING
• Lifting must be done by a trained operator.
• Obey all work site-safety requirements, the safety instructions for the lifting equipment, and the
safety information in this manual.
• Misuse of lifting equipment can cause the load to become unstable, which can cause property
damage, personal injury, or death.
WARNING
Make sure that the waste hopper handle is in the locked position with the safety latch engaged.
Obey local regulations when discarding parts, materials, abrasive, and wastewater. Refer to
Recycling and end of product life
on page 110.
Repair or replace parts identified in the preventive maintenance schedule or if the parts are
defective, deteriorated, corroded, or damaged.
• The maximum weight that the waste-abrasive collection bag can hold is 1,000 kg (2,205
pounds).
• Use lifting equipment that can lift and move the bag safely.