Hypertherm EcoSift, Руководство оператора

Страница: 81 / 188

Preventi
ve maintenance
Preventive maintenance
EcoSift Operator Manual 809500 81
Clean the waste hopper
Required parts, tools, and materials
Forklift
PTFE tape or thread sealant
Flowing water and a hose
Recommended materials
Shovel
Do this task when the EcoSift is not operating.
1. If there is a waste-abrasive collection bag in the hopper, remove it.
2. Disconnect the hopper overflow tube from the elbow fitting on the outside of the hopper.
3. Remove the hopper overflow tube from the coupling on the inside of the hopper.
4. Insert the forklift forks into the opening in the base of the hopper with the forks spread as wide as possible.
5. Move the hopper to the cleaning area.
6. Keep the forklift mast tilted back and release the hopper tilt latch.
It could be necessary to tilt the forks forward or backward to decrease tension on the hopper tilt latch before
the latch releases.
WARNING
Slippery surface
The floor can be slippery when wet.
WARNING
• Lifting must be done by a trained operator.
• Obey all work site-safety requirements, the safety instructions for the lifting equipment, and the
safety information in this manual.
• Misuse of lifting equipment can cause the load to become unstable, which can cause property
damage, personal injury, or death.
WARNING
Make sure that the waste hopper handle is in the locked position with the safety latch engaged.
Obey local regulations when discarding parts, materials, abrasive, and wastewater. Refer to
Recycling and end of product life
on page 110.
Use a forklift to move the hopper to the cleaning area. Do not use a crane.
Put the hopper on the forks with the release latch toward the vehicle.