HyperFlight
Sokol Assembly Guide
Recommended Control Throws & Mixes
Elevator
3 mm up, 2 mm down
Ailerons
3 mm up, 2.5 mm down
Recommended Servos
Elevator
Ripmax SD100
, Dymond D47,
MKS
DS65K
,
Power HD DSM44
Ailerons (1
servo)
Ripmax SD100
, Dymond D47,
MKS
DS65K
,
Power HD DSM44
Recommended Powertrains
Mild
20mm 30g KV 3000 outrunner,
Graupner 4.7x4.7 or 6x3
folder,
Hyperion 2S 900 mAh G3
LiPo
, 15A ESC
Good
Mega 16/15/3, Graupner
4.7x4.7,
Hyperion 3S 1100 mAh G3
LiPo
, 30A ESC
Fast
Mega 16/15/2, APC
4.1x4.1,
Hyperion 3S 1600 mAh G3
LiPo
, 60A ESC
Mad
Mega 16/15/3, Graupner
4.7x4.7, 4S LiPo eg 2x,
Hyperion
2S 1100 mAh G3 LiPo
, 50A ESC
Fuselage
In necessary push the Bowden Cable outer tube though the hole in the rear of the fin,
so only 1mm is showing. Glue this in place with a little medium CA (Super glue).
Glue the elevator horn in place using epoxy, preferably thickened with micro-balloons,
and smoothed to make a fillet around the horn. Glue it about half way back on the
elevator, to allow for movement, and to improve the geometry.
Bend an L shape in the wire push rod, and attach it to the horn as shown. No keeper is
needed.
(c) 2013 HyperFlight Drybank Farm Fosse Way Ettington Stratford-on-Avon Warwickshire CV37 7PD
4
