GENERAL INFORMATION 1-2
PRECAUTIONS AND GENERAL INSTRUCTIONS
Observe the following items without fail when disassembling and reassembling motorcycles.
□ Do not run engine indoors with little or no ventilation.
□ Be sure to replace packing, gaskets, circlips, O-rings and cotter pins with new ones.
□ When tightening cylinder head or a case, torque the bolt or nut of larger thread diameter first and then
proceed to that of smaller diameter. They should also be tightened crosswise from inside to outside to
the specified torque.
□ Use special tools where specified.
□ Use genuine parts and recommended oils.
□ When two or more persons work together, pay attention to safety of each other.
□ After the reassembly, check parts for tightness and operation.
□ Treat gasoline, which is extremely flammable and highly exposive, with greatest care. Never use gaso-
line as cleaning solvent.
Warning, Caution and Note are included in this manual occasionally, describing the following contents.
WARNING ................ The parsonal safety of the rider may be involved. Disregarding this information
could result in injury to rider.
CAUTION ................. These instructions point out special service procedures or precautions that must
be followed to avoid damaging the machine.
NOTE ..................... This provides special information to make maintenance easier or important inst-
ructions clearer.
REPLACEMENT PARTS
When you replace any parts, use only genuine HYOSUNG replace-
ment parts, or their equivalent. Genuine HYOSUNG parts are high
quality parts which are designed and built specifically for HYOSUNG
vehicles.
HYOSU
NG
GENUIN
E PART
S
CAUTION:
Never reuse a circlip after it has been removed from a shaft, it should be discarded and a new circlip must be
installed.
When installing a new circlip, care must be taken not to expend the end gap larger than required to slip the
circlip over the shaft.
After installing a circlip, always insure that it is completely seated in its groove and securely fitted.
CAUTION:
Use of replacement parts which are not equivalent in qual-
ity to genuine HYOSUNG parts can lead to performance
problems and damage.
