EN © 2020 HYKKER.
All rights reserved.
CHRONO 4
7
You can set how long your device is on hold before fading the screen. Select the
icon from the menu
. From the menu
[Settings] > [Phone settings] >
[Misc.settings] > [LCD backlight].
Here you can specify the time after which the
screen should be locked/deactivated.
6. Before the first start
6.1 Installing a SIM card
When you switch on a smartwatch that has a PIN-protected SIM card inserted,
you will have to enter this number.
The Hykker Smartwatch can act as a simple mobile phone. You can install a SIM card
to handle calls and to receive and send SMS messages.
To correctly insert the microSIM card from a switched off smartwatch, remove the
cover (using your fingernail to undermine the cover). Take the battery out. Open the
card protection cover with your fingernail - slide it slightly towards the strap and lift
it gently. Insert the microSIM card into the slot according to the notches on the
frame. Lower the safety flap gently and push it slightly downward to the middle of
the smartwatch. Install the battery carefully and paying attention to where the
contacts are situated, and close the cover.
6.2 Installation of the memory card.
The memory card is not included in the set and you need to purchase it
separately.
Use only compatible and manufacturer-approved memory cards. Using
incompatible memory cards can damage the device and delete data stored on them.
Incompatibility may include incorrect card format (microSD format required) or excessive
card capacity (over 32 GB).
To correctly insert the memory card remove a cover from a switched off
smartwatch, (using your fingernail to lift the cover). Take the battery out. Insert the
microSD card into a suitable slot with the contacts fitted into the smartphone. Install
the battery carefully and close the cover.
6.3 Charging the battery
Charge the battery before the first use. Charge the battery pack with the cable
included in the set. In case of any problems with the battery or if in need of a replacement,
the device should be delivered to the manufacturer's service center. Use only chargers
and cables approved by the manufacturer. Using incompatible chargers or cables can
cause explosion of the battery or damage to your device. When the battery is fully
discharged, the device may not turn on, even if it is plugged and charging.
Incorrect connection of USB plug can cause damage to the AC adapter or the device.
