• Connect the conventional zone line’s terminals to the
relevant connector.
• Install the Alarm and the Line EOL resistors and connect
to the relevant connector. Note: resistor’s value should be
indicated in the control panel’s datasheet / instructions
manual.
•
Connect the sounder line’s terminals (optional) to the relevant
connector and ensure you install the correct sounders R
EOL
resistor.
8
7
10
The conventional expander will power up and will be ready
for commissioning.
• Connect the power supply terminals (EN54-4 certified
power source is required).
• Connect the power supply’s monitoring inputs (optional).
• Screw the lid to the back box using the supplied plastic
screws and refit top and bottom front plastics that cover
screw housings.
• Put the QR code available in the box either on the system
map or on the dedicated pages at the end of conventional
expander manual.
GREEN LED
MAINS FAULT
PULL-UP TO 3V3
BATTERY FAULT
BATTERY
CHARGER FAULT
BATTERY O/C
ext. power (
-
)
ext. power (
+
)
ZONE
LINE (+)
CIE
ZONE
LINE
ZONE
LINE (-)
LINE EOL (
+
)
ALARM
EOL (
+
)
ALARM
EOL (
-
)
LINE
R
EOL
ALARM
R
EOL
LINE EOL (
-
)
CIE
SOUNDERS
R
EOL
SOUNDER
LINE
SOUNDERS
LINE (
+
)
SOUNDERS
LINE (
-
)
SOUNDERS
EOL (
+
)
SOUNDERS
EOL (
-
)
TAU-CEM-01
HYFIRE TAURUS CONVENTIONAL EXPANDER MODULE
QUICK START GUIDE
Unit B12a, Holly Farm Business Park, Honiley, Warwickshire, CV8 1NP
T: +44 (0)1926 485282, E: [email protected], W: www.hyfirewireless.com
L50-MEC-1400 (Rev_P.2)
