Hydrotech Water 15010670, Инструкция по установке и эксплуатации

Страница: 12 / 26

12
If the water heater has been exposed to both
iron and hardness for a long period of time,
replacement of the heater tank may be the
only practical solution to prevent continued
staining originating from this source. After
completing the installation of the chemical
free iron filter, clean the water heater by fol-
lowing these instructions:
1. Shut off the energy supply to the water
heater and close the heater inlet water
valve.
2. Drain hot water tank completely. Open in-
let water valve, allowing heater tank to be
refilled with iron-free water. Continue
flushing until the water runs clear to the
drain.
3. If, after approximately 30 minutes of flush-
ing, water does not clear, terminate the
flushing operation. Refill hot water heater
with water and pour approximately 1/2
gallon of household bleach into the top of
the heater tank. Allow bleach solution to
stand in tank for 20 to 30 minutes. Flush
the tank again until water is clear at the
drain. Turn energy supply on.
NOTE: If water does not clear in approxi-
mately 10 minutes, water heater should
probably be replaced.
Water Heater
Programming Instructions
1. Press SETTINGS to enter programming. If the system has been inactive, you may
have to hold and press SETTINGS to unlock the display screen. Press UP or DOWN to
select which setting to modify.
2. To adjust a value, MANUAL REGEN. When the display flashes, the value may be
changed. Press UP or DOWN to change the value. Press MANUAL REGEN again to ac-
cept the value.
3. Press UP or DOWN to advance to the next option.
4. At any time, press SETTINGS to return to previous home screen menu.
Menu - Level 1
Press SETTINGS key
TIME
12:00AM
REG.TIME
12:00AM
DAYS
3
Example
Page 1
STAR
PLUMBing
Page 2
TEL (552)
764-1234