HydroMist CentraMist series, Руководство пользователя

Страница: 9 / 12

HydroMist
HydroMistUSA.com
9
9. Slide the Clamping Bolt (13-C) into a Washer (13-A).
10. Insert the Clamping Bolt (13-C) into the curved slot in the Mounting
Bracket (11), through the lower hole of the Upper Mounting Pole (1) and
out through the curved slot on the other side of the Mounting Bracket (11).
11. Slide a Washer (13-A) over the end of the Clamping Bolt (13-C), then
thread the Locking Nut (13-D) onto the threaded end of the Clamping
Bolt (13-C), and tighten the nut until the Mounting Bracket (11) is snug
against both sides of the Upper Mounting Pole (1).
WARNING: Before connecting the fan wires to building wires, turn the
power breaker to OFF or otherwise disable power from the building wires.
12. Press the other end of the 1/4-Inch Nylon Tube (14) into the the 3/8-Inch x
1/4-Inch Reducer fitting. Make sure to push the tube into the smaller end of
the fitting, ensuring that the tube is inserted completely into the fitting. The
3/8-Inch side of the Reducer fitting connects to a misting pump.
13. Use one Wire Nut (13-F) each to connect wire pairs together, making
sure to screw them on tight and have no bare wire exposed.
a. Brown fan wire is HOT and connects to black building wire.
b. Blue fan wire is NEUTRAL and connects to white building wire.
c. Green/yellow striped fan wire is GROUND and connects to green
solid or bare copper building wire.
~or~
bare
copper
HOT NEUTRAL GROUND
Operation
Power & Speed Control
The ceiling fan model does not have a built-in switch and does not have
speed controls. It is intended to be connected to building wiring with a self-