STEP 2:
Install carbon pre-filter. The pre-filter can
only be installed in the manifold in the
position shown. The other two openings
in the manifold are for the membranes.
STEP 4:
Install RO membranes.
Carefully push the first
membrane into the position
shown. Push it straight down
into the hole of the manifold
until both o-rings are seated
in the hole. Do not rock
membrane back and forth
to install. Install housing
over membrane.
Repeat this step for
second membrane.
STEP 10:
Install blue 3/8" purified water tubing and 3/8" black waste
water tubing into corresponding elbow connector fittings as
shown. The 3/8" inline shut-off valve should only be installed
on blue purified water line to shut system off/on.
NEVER install the shut-off valve on the black waste
water line!
This has to be able to drain waste water freely
and without obstruction.
STEP 1:
Put a thin layer of lube on o-rings of 3 housings
and both o-rings on 2 membranes.
STEP 7:
Install the pressure gauge assembly. Push short length of
tubing into the left side of the gauge. Push the other end
of the tubing in to the elbow connector fitting*.
STEP 9:
Install 1/2" white inlet tubing. Push tubing into pressure
gauge fitting. Push garden hose inlet fitting
onto other end of tubing. The fitting is
compatible with garden hoses and
hose bibs. Other feed valves are
available, on inquirey.
STEP 5:
Lube the o-rings on each of the 3 elbow connector fittings*
and push them into the corresponding ports on the manifold.
The back of each elbow connector fitting has a symbol that
corresponds to the symbol next to the manifold ports.
STEP 6:
Install the pressure gauge assembly. Push short length of
tubing into the left side gauge. Push the other end of the
tubing into the white 1/2” QC elbow feed fitting*.
STEP 8:
Install the support leg as shown.
STEP 3:
Use the support leg as a filter housing
wrench to tighten down the housing. Once the
housing is hand-tight, crank down one quarter
turn with the wrench. There’s no need for the
flange on the bottom of the housing to
come in contact with the flange
on the manifold.
NOTES:
The black drain line must be unrestricted.
Under normal parameters, the system is
designed to drain at a ratio of 2 parts
drain to 1 part product water (using green elbow fitting).
*For 1:1 ratio, use orange elbow fitting instead of green.
The optional
drain saddle
(shown above)
is an alternative way
to run your drain line. You can also be creative in using the drain
water, i.e. landscape drip systems, refilling household storage
tanks, etc.
Flush the system for 1 hour before using product
water. Always take your product water PPM
readings after 5 minutes of running the system
once it has sat idle for several hours.
CONGRATULATIONS!
The
Evolution-
RO
1000
®
should now be producing pure
water at fast flow rates.
For further assistance or more detailed information please
refer to the main instruction manual.
For all return, warranty, and repair issues please
DO NOT contact your dealer.
Contact Hydro-Logic directly
at:
888-426-5644
or
www.hydrologicsystems.com.
See back page for options and accessories.
Apply lube here
Tighten
Apply lube here