Hydrofarm Xtrasun II XT2AW, Инструкция по эксплуатации

Страница: 2 / 8

INSTRUCTIONS
www.Hydrofarm.com 2
OVERVIEW
Thank you for purchasing the XT2AW Xtrasun
Wing II Reflector. It is designed to give you
incredible value for a budget-priced reflector. It
provides super wide and bright light delivery, yet
is very lightweight.
This reflector accepts single-ended HPS lamps in
250W, 400W, 430W, 600W, 750W, and 1000W as
well as single-ended metal halide lamps in 250W,
400W, 600W, and 1000W. The base type required
is mogul (E39).
WHAT’S IN THE BOX
• 1 – XT2AW reflector with socket and cord set
• 2 – Reflector hangers (S-hooks)
• 1 – Cable tie
ASSEMBLY & HANGING
1. Review parts list to ensure that all parts are
in the package.
2. Remove protective film from reflective wing.
3. Attach the aluminum wing to the reflector
mounting bracket by placing the side without
the two small rectangular slits so that it is
held by the two small tabs located at the
socket end of the mounting bracket on either
side of the “V”-shaped center divider. (see
Photo 1).
4. Secure the front (non-socket) end of the
wing to the mounting bracket using the
tension clip located on the front part of the
mounting bracket (see Photo 2). Also ensure
that the two small rectangular tabs on the
mounting bracket go into the slits on the
reflective wing.
5. Insert reflector hangers (S-hooks) into holes
on either end of the reflector and hang
reflector in an appropriate location (see
Photo 3).
6. Use the included cable tie to secure the
electrical cord to the hanging chain so that
its weight doesn’t tilt the reflector.
CLEANING THE REFLECTOR
1. Unplug the reflector and allow it to cool.
2. Lift the reflector off its hanging mechanism.
Photo 1
Photo 2
Photo 3
Set the reflector bulb-side up on a sturdy
surface. Optional: Place the reflector on a
towel or soft cloth.
3. Unscrew the lamp (always use gloves if
possible when handling HID lamps, as skin
oils left on the glass envelope can cause hot
spots). Set aside.
4. Mix mild soap and warm water and apply
sparingly with a clean washcloth. Dry with
a second washcloth. Flip reflector over to
cleanse both sides.
5. Run a dry, soft washcloth over lamp to
remove dust particles.
6. Screw the bulb back into the reflector.
Reattach the reflector to its hanging
mechanism and plug in the power cord.