USING THE MODULAR T5 LIGHT STRIP WITH TIMER
1. Open the Modular T5 Light Strip box. Set the detached power cord aside. Note the bulb and
reflector are already attached to the strip. If you will be setting up multiple strips, it may be
beneficial to open all of them at the same time.
2. Remove the fixture from the box. Plug the power cord to light the fixture. If the lamp is not on, flip
the on/off switch to the power the fixture.
MOUNTING OR HANGING THE MODULAR T5 LIGHT FIXTURE
1. Screw the flush mounting clips to a level surface.
2. Clip the Modular T5 Light Strip into the mounting clips.
3. Plug the power cord into the Light Strip when using a single strip.
4. When you want to vertically hang the fixture, clip the strip into the hanging clip. Attach rope, chain
or S hook on top of the clip.
NOTE: When flush mounting multiple strips, slide the Light Strips into the optional Modular T5 4
Strip Dock (JSFD) and connect using the Link Cord (JSFL). Once you have assembled the fixture,
plug the power cord into the Modular T5 4 Strip Dock.
SETTING THE TIMER
To set the timer to operate on a 12 hours on/12 hours off schedule or an 18 hours on/6 hours off
schedule, simply press either the “12” button or the “18” button at the specific time of day that you
would like your “on” cycle to begin. As an example, to have the light turn on at 6:00 p.m. and stay
on for 18 hours until 12:00 p.m. the next day, press the “18” button at 6:00 p.m. and the timer will
automatically keep the light operating for 18 hours then turn it off for 6 hours. To reset the timer, press
either button again and the fixture will begin the program starting from that time. Note that each
button has an LED indicator light next to it which will illuminate when it is pressed and the timer is
activated.
CHANGING THE LAMP
1. If using the Modular T5 Dock, detach the strips from the dock before replacing the lamps.
2. Rotate lamp clockwise to loosen and lift from sockets.
3. Insert replacement lamp and rotate counterclockwise to secure in sockets.
CARE AND CLEANING
1. Unplug the T5 and allow to cool.
2. Remove the lamps and set aside.
3. Mix warm water and mild soap and apply sparingly to the strips with a clean washcloth. Dry
system with a second washcloth.
4. Run a dry, soft washcloth over bulbs to remove dust particles.
5. Install lamps back into the strips.
6. Plug in the power cords.
DO NOT immerse the system in water.
DO NOT use gasoline, paint thinner or other chemicals to clean the system.
3
