The information contained herein is intended for the use of the individual(s) named above and those authorized to receive it. Dissemination, distribution
or copy of this information is strictly prohibited.
B.
Repeat Steps 6 and 6A on the other side of the enclosure.
7.
Align the “F” post within the opening utilizing the space between the “C” panels. Install an Inside
Anchoring Bracket (Fig 1B) at the bottom of the “F” post.
A.
Insert an Inside Roof Clip into the “D” (roof) panel at the “F” post stud. Using one (1) hex headed
screw, attach the clip to the “F” post (Fig 1C).
8.
Provide a ground-fault interrupter device in all electrical circuits per all applicable codes. Install the
heater(s) as per manufacturer’s instructions and governing local and national codes.
9.
For maximum protection, it is suggested that the area between the bottom of the enclosure and the
concrete base should be caulked except for the “C” panels. DO NOT CAULK THE BOTTOM OF
THE “C” PANELS.
10.
REMOVE THE PVC MASKING FILM IMMEDIATELY AFTER INSTALLATION. If the panels
get wet with the masking film in place, water will irreversibly stain the panels. Summertime heat will
bake the masking film onto the panels.
