HYDRO-RAIN 04052, Руководство пользователя

Страница: 6 / 48

6
1. Select a Location
When choosing a location for your HRC 100 C, consider the
following:
• Choose location near a power source (if hard wiring) or
electrical outlet when using the supplied power cord .
• Ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius) .
• Place it away from direct sunlight if possible .
• Ensure at least 9” of space to the left of the sprinkler
controller box for the door to swing open after
installation .
• Locate the controller where there is easy access to
sprinkler wire (from valves) . If mounted in an outdoor
location, shut the compartment door to keep the
controller safe from weather damage . To lock: insert
the key and turn clockwise to the locked position .
Note: Sprinkler controllers are weather-resistant to UL-50
and ETL
®
Listings, but should not be placed in areas where
continuous water could cause damage.
2. Mount the Controller
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• Install a No . 8 screw (included) into wall in the upper
template location . Leave the screw head protruding 1/8”
(3mm) from wall . Use expanding anchors (included) in
plaster or masonry, if necessary, for a secure hold .
• Slip the HRC 100 C over protruding screw (using keyhole
slot in back) . See figure 2
• Drive a No . 8 screw through one of the two pre-formed
holes located in lower back cabinet . See figure 2
Figure 2: Hang timer on screw using keyhole
Keyhole
Pre-formed
mounting holes
No. 8 Screw
Wall
1/8"
MOUNTING TEMPLATE
GABARIT D`INSTALLATION
PLANTILLA DE MONTAJE
4.17”
(106 mm)
Figure 1: Use Mounting Template (included)