hydro innovations hydrogen1, Руководство по эксплуатации, Страница: 4 / 8

HOT
COLD
HEAT
EXCHANGER
AND FAN
HEAT
EXCHANGER
AND FAN
HEAT EXCHANGER
COOLING METHOD
HEAT EXCHANGER
COOLING METHOD
HEAT EXCHANGER
COOLING METHOD
W
ALL
W
ALL
Heat Exchanger Cooling Method:
The third most efficient method is a small
radiator with an attached fan. There are two
different ways to do this, inline or closed loop.
Inline:
The heat exchanger can be used inline on the
HOT water discharge hose. The hot water
would pass through the heat exchanger
which allows the fan to remove a majority of
the heat before the water returns to the
reservoir. The heat exchanger and fan must
be mounted OUTSIDE the grow room and
must be installed in the hot water discharge
of the HydroGEN to be the most effective. This
would be recommended for someone that
uses the HydroGEN more than 30 minutes an
hour since it is only cooling while water is
flowing through the HydroGEN unit.
Closed Loop:
You can use a secondary submersible pump
in your reservoir that's connected directly to
the heat exchanger and exits back to your
reservoir. Doing so this allows for constant
cooling of the reservoir since the pump can be
constantly running. You will need a separate
pump, plugged into your co2 monitor, to
operate the HydroGEN.
6
7
INLINE
CLOSED
LOOP
The hot water would
pass through the
heat exchanger
which allows the fan
to remove a majority
of the heat before
the water returns to
the reservoir.
Doing so this allows
for constant cooling of
the reservoir since the
pump can be
constantly running.
CO2
MONITOR
CO2
MONITOR