Hydro-Force AC040, Руководство оператора

Страница: 8 / 23

8
8
VACUUM HOSE
1. Attach a vacuum hose to your vacuum source. This may be either a portable
extractor, or truckmounted vacuum system. Attach a male vinyl cuff to the end of
your vacuum hose and attach to either a 1.5” DustDowner (AH127) or 2” DustDowner
(AH128).
2. Connect the DustDowner to another section of vacuum hose with male cuff attached.
This second hose will connect via female Flash Cuff (AH204) to the male Starter Flash
Cuff (AH224) on the vacuum box.
a. Note: some users like to run a long hose to the vacuum box, and then attach
the DustDowner with a short 3’ section so they are close to the ball valve that
controls water flow while working. This adds the weight of the solution hose and
brass to the end of your hose run and may make it more difficult to clean ceiling
ducts (since you have to pull both the vacuum hose and solution hose off the
floor). If most of the vents you clean are on the ground, then having the valve
closer to the vent might be preferable since you can reduce water
consumption because you don’t have to walk as far to reach the shut off valve.
3. Connect the DustDowner to your solution hose. Place a ball valve (AH54) on your
solution hose so you can control the flow of water.