Page 2
4.
Installation
4.1 Recommended Tools and Equipment for this Installation
Electric Drill –
Impact, Variable Speed, Reversible
Drill Bits
Masonry: 6mm, 10mm
Steel: 6mm, 10mm, 12mm
Hacksaw
Screwdriver -
Ө
3mm
Screwdriver -
⊕ 6mm
Spirit Level
Tape Measure – 5m
Hammer
Spanners
Sockets: 8mm, 11mm, 13mm
Flat/Ring: 10mm, 11mm, 13mm, 14mm
Step Ladder – 1,7m ~ 2m high
Extension Lead – to suit
4.2
Installing the Operator and Rail
With the Release Lever pointing away from the
Spring, fit the Carriage to the Base using 4
Phillips Screws.
Attach the Release Cord to the Release Lever.
While engaging the motor shaft with the
sprocket, place the Rail on top of the Power
Head.
Bolt the rectangular Saddle to the Cross
Member on the Rail in the space at the front of
the operator.
Secure the Tapered Saddles to the four Studs
with Flange Nuts.
Mount the Anchor Bracket to the front wall on
the door centre-line.
Secure the foot of the Rail to the Anchor
Bracket.
Once the Power Head has been suspended, fit
the Connecting Arms as shown, using the Pins
and ‘R’ Clips.
Overlap the Arms and bolt them such that the
short section is horizontal.
Base
Carriage
Release
Lever
Spring
Horizontal
Pin & ‘R’ Clip
Bolts
