
•
Slot Base Foot A onto the Fan Base and pass the Power Cord through the Base Hole (see
image 1).
•
Slot Base Foot B on top of Base Foot A so that both sections are fixed together (see image
2).
•
Screw the Bolts into the holes to secure the Base Feet. Pass the Power Cord through the
Cord Channel and place the Plastic Grip over the top of the Power Cord. Using the screws
provided screw the Plastic Grip to the Base Foot to hold the Power Cord in place (see image
3).
Instructions for use
Plug into 220-2400V AC mains outlet and select
desired speed (1-3). Press 0 to stop the fan.
Pressing the Oscillation Button downwards which
is located above the Speed Buttons will cause the
fan to sweep back and forth. Releasing the button
will stop the oscillation. The fan will not oscillate
when the timer switch is set to 0.
Timer
Turn the Timer Switch anti-clockwise to the
desired time. The fan will automatically stop when
the Timer Switch reaches zero. When you do not
wish to use the timer set the switch at 1.
If the timer switch is set to 0 the fan will not
operate even if you set the desired Speed
Buttons.
Cleaning and Maintenance
•
Switch off the power supply and pull out the plug from the mains socket before cleaning.
•
A soft dry cloth is usually adequate but can be moistened with mild detergent solution if
required.
•
Never clean the unit with solutions such as thinners and polishing powder etc.
Plug Replacement
•
The appliance must be connected to a 240 volts AC supply by means of a three pin socket.
•
The appliance is supplied with a rewireable 13 amp 3 pin plug fitted with a 3 amp fuse.
Should the fuse require replacement, it must be replaced with a fuse rated at 3 amp and
approved to BS1362.
•
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other
reason, then the cut off plug should be disposed of safely to prevent the hazard of electric
shock.
•
There is a danger of electric shock if the cut off plug is inserted into any 13 amp socket
outlet.
Version 1.0 March 2006