Operating Instructions and Parts Manual
Hand Dryers
2. Drill 4 holes
(A. B. C. D. 8 mm (5/16") diameter:35 mm (3/8") depth.)
3. Take off the mounting instruction sheet.
Hammer dowels into 4 holes.
Installation
1. Fix the position card on the wall.
Suitable height for hole "D" is 130 cm (50") from ground.
4. Remove the housing from the base plate; fix the base
plate firmly on to the wall.
5. Connections:
A. Connect the live wire (colored red or brown) to
the terminal block marked "L".
B. Connect the neutral wire (colored black or blue)
to the terminal block marked "N".
C. Connect the ground wire (colored green and
yellow) to the green screw marked " ".
6. Attach housing back to base plate.
WARNING
WARNING
WARNING
Disconnect power before
installation or servicing.
This product intended for
installation by a qualified service person.
Use AWG NO. 14 solid conductor for wiring.
NOTE: Do not install dryer over washbasin.
All units must be supplied with
a 3-wire service. The ground wire must be
connected to the dryer's backplate.
Failure to properly ground unit
could result in severe electrical shock and/or death.
General safety information
DANGER
3
Wiring Diagrams
Sensor
Heater
Motor
Relay Contact
Timer
C
Capacitor
Thermostat
G
N
L
CYCA26F/CYCA26CSF
www.hycomanufacturing.co.uk