Always ensure there is no concealed electrical wiring or pipework prior to drilling
into the surface.
•
Using the template or dimensions supplied and ensuring a horizontal level, mark out
the three holes for mounting the dryer onto the desired surface. Maintain a clear
space of at least 120mm from the sides of the dryer and 500mm below the outlet.
•
Drill the 3 holes in each corner as shown and insert the wall plugs.
•
Remove the dryer cover via the 2 x counter sunk screws, located at opposite sides
of the cover (Allen key tool provided).
•
Before mounting the dryer to the surface, make provisions for the wiring.
For concealed wiring, use the knock out in the back plate. Do not leave rough
or sharp edges as this could cause damage to the supply cable.
•
Offer the dryer to the wall, insert the screws and tighten fully.
•
Refit the dryer cover using the 2 x counter sink bolts.
4
