9
or Phone 2 port.
Please refer to the table in section 3.1.1 for detailed information. While seting up, please
follow the instructions as follows :
a) When the HT-822P IP ADAPTOR fails to set the LAN Port and PC Port IP addresses,
it reports 0 on *01 or *02 Star Commands.
b) When the PC port is configured into Bridge Mode, it also report zero.
c) *03 and *04 can be dialed to set the LAN Port IP address and PC Port IP address. For
example, if you want to set the PC Port
’
s IP address to 192.168.5.10, please press
the following keys orderly :
“
*04192.168.5.10#
”
. Note : enter Symbol
“
*
”
replace
“
.
”
and end with
“
#
”
.
d) A special star (*) command (*09987456) can be dialed to reset both LAN port and PC
port to the factory default IP. By the new firmware, the default setting was the LAN
port is DHCP mode, the PC port is bridge mode.
e) The star command *11983185922 can be dialed to reset the system configuration or
return to the default configuration.
3.3 Make Phone Calls
3.3.1 Using Star (*) Commands for Phone Operations
Refer to the table in section 3.1.2 for detailed values of the star commands for phone
operation.
3.3.1.1 Call-waiting/flash
When you are talking on the phone and another call comes in on your phone extension, a
short tone sounds in your handset. You can give the waiting indications such as accepting
the call, or neglecting the call.
Note: This function only support by SIP protocol.
3.3.1.2 Call Hold
Call Hold lets you put a caller on hold for a certain period of time. There are two kinds of
call hold:
a) When you are in the conversation with a party, you can press
“
*42
”
on the phone
keypad to place the first party on hold. You will hear a dial tone. Enter a new phone
number to make another call. After finishing the second call, you can press the
“
*42
”
again to return to the former call on hold.
b) When you are talking on the phone and another call comes in on your phone
