Hy-Gain HAM IV, Инструкция по эксплуатации

Страница: 8 / 20

OUTSIDE TOWER OPTIONAL KITS:
Referring to Figures 5, 6, and 7, an outside
tower or pole mount is made in the same manner
except that the rotator is fastened by four (4)
bolts only (not six) to the Lower Mast Support,
PN 51467 10. Since the eccentricity of the
rotator turning in reference to the tower is no
longer important, the shimming procedure is not
necessary. The four (4) bolts must be torqued to
the same specification and the 8-wire cable
securely fastened. The lower mast should be
pinned with the 5/16"-18 x 4" bolt as shown in
Figure 7. HEAVY-DUTY LOWER MAST SUPPORT
KIT (51467-10) (Optional)
The stock HAM W is intended to mount on the
base plate inside of the tower. However, in
some instances, outside tower or mast mounting
is desired as per Figures 5 and 6. This kit, P/N
5146710 contains a heavy-duty lower mast
support and the necessary hardware to facilitate
mounting the HAM IV on top of a tower stub or
mast.
Figure 7
Rotator Mounting with Lower Mast Support
8
CinchTM a Division of Labinal Components & Systems, Inc.
AMP* is a registered trademark of AMP-Barrel, AMP Inc.,
939 E. Park Dr. Harrisburg, PA
WEATHER-PROOF CONNECTOR KIT
(Optional)
The Cinch' Connectors on the Rotor Unit may
be replaced by AMP© CPC weatherproof
connectors. The AMP© connectors, when
properly installed, will enhance the reliability
of your HAM IV.
This kit contains the following
PN Description Qt
650179 Amp Receptacle, 9 pin 1
650291 Contact, Pin 8
650180 Amp Receptacle shell 2
650181 Amp plug 1
650293 Contact, Socket 8
Instruction Sheet 1
CAUTION
The rotator is designed for vertical operation
with the bell shaped housing in the up position.
Water and other contamination will get into the
motor unit if it’s mounted horizontally or
upside down.
CAUTION
When the rotator is installed using the lower
mast support kit, the antenna size must be
restricted to 7.5 square feet of wind surface
area.