Hy-Brid Lifts PA-1030, Инструкция по эксплуатации и безопасности

Страница: 13 / 36

SECTION 2
SAFETY
2.8 | SAFETY GUIDELINES
Only qualified operators may operate this unit
• All operators must read and understand the Operation and Safety Manual. They must understand all
decals and warning labels on unit.
• Do not work on platform if your physical condition is such that you feel dizzy or unsteady in any way.
• Do not neglect/misuse machine. Report any misuse of equipment to proper personnel.
• Prevent unauthorized use; when unit is not in use, remove key.
• It is recommended all personnel on unit wear approved personal protective equipment (PPE), i.e. head
gear.
Use machine only for purposes for which it was intended
• Lift should never be used as a crane.
• Do not exceed the load capabilities of the platform.
• Distribute load evenly over platform floor area.
• Never use unit as electrical grounds for arc welding.
• Do not override any hydraulic, mechanical, or electrical safety devices.
Check job site for unsafe working conditions
• Watch out for others. Keep others clear of operating platform. Never allow others to pass under a raised
platform or position the platform over someone.
• Avoid contact with fixed objects (walls, buildings, or other machinery, etc) or moving vehicles
(automobiles, cranes, etc).
• Follow any applicable national traffic regulations.
• Never use outdoors. Lift is not designed for windy conditions or electrical storms.
• Unit must be on hard level surface before elevating. Do not operate on incline or uneven surface.
• You must maintain a clearance between any part of the machine, or its load, and any electrical line or
apparatus. Follow local power line clearance regulations.
DO NOT OPERATE MACHINE NEAR POWER LINES.
THE PLATFORM AND ENCLOSURES ARE NOT
INSULATED.
Equipment is only as safe as the operator
• Do not use ladders or scaffolding on the platform to obtain greater height.
• Do not enter or exit platform while machine is in motion.
• Never mount or dismount a raised platform.
• Make sure entry gate is secured before operating machine from the platform.
• Never belt or tie off to an adjacent structure.
• Secure tools and materials.
• Personnel must maintain a firm footing on the platform floor and work only within the platform area.
• Never move the unit with a person in the platfom. Never move the unit in the elevated position.
Before operation, ensure that the machine is properly serviced
• Do not use machine if it is not working properly.
• Make sure platform rails and pins are secured.
• Operator shall use the maintenance lock when performing all types of maintenance procedures.
• Do not smoke while charging the battery.
• Perform inspections and preventative maintenance at the recommended intervals. (See the “Before you
operate” section of this handbook)
13 OPERATION & SAFETY MANUAL PA1.1-S REV A