MP34.2823
23SEP11
WARNING:
HITCHING AND STORING JACKS
THE OPERATOR MUST BE SURE THAT
THERE ARE NO OBJECTS UNDER THE TRAILER AND
THAT ALL PEOPLE ARE CLEAR OF THE TRAILER.
OPERATING PROCEDURES
2. Push the rear down arrow (RETRACT button) until
the weight of the trailer is off the rear jacks.
3. Hitch the trailer to the tow vehicle according to the
manufacturers instructions. Use the existing landing
gear or the front UP (EXTEND jacks) and DOWN
(RETRACT jacks) arrows.
1. After the trailer is securely hitched to the tow vehicle,
HITCHING
1. The master power switch and the HWH canopy lift control
panel key switch must be on to hitch the trailer and store the
The manual UP (extend jacks) and DOWN (retract jacks)
arrows will function anytime the master power switch and
the HWH canopy lift control panel key switch are on if the
"AUTO LEVEL" or AUTO STORE lights are not flashing.
STORING JACKS
NOTE: If the trailer is equipped with an air suspension,
it is recommended to not connect the tow vehicle air
supply to the trailer until the trailer is hitched to the
tow vehicle and the jacks are not touching the ground.
and the green "TRAVEL MODE" light is on.
lights are out, the jacks are in the STORE/TRAVEL position
3. The trailer can be moved as soon as the red warning
2. Turn the master power switch and HWH key switch off
OR SECURELY SUPPORTED BY THE AUXILIARY
IF THE TRAILER IS HITCHED TO A TOW VEHICLE
ONLY USE THE "STORE" BUTTON
CHECK THAT ALL JACKS ARE FULLY RETRACTED INTO
WARNING LIGHTS. IT IS THE OPERATOR’S RESPONSIBILITY TO
CREATE A DRIVING HAZARD. DO NOT RELY SOLELY UPON
SEVERE DAMAGE TO THE JACKS AND OR THE TRAILER AND
WITH THE LEVELING JACKS EXTENDED CAN CAUSE
WITH STRAIGHT-ACTING JACKS. MOVING THE TRAILER
OR IN THE EXTEND POSITION. THIS TRAILER IS EQUIPPED
LEVELING JACKS ARE STILL IN CONTACT WITH THE GROUND
DO NOT MOVE THE TRAILER WHILE THE
THE STORE/TRAVEL POSITION.
JACKS.
WARNING:
WARNING:
jacks.
button has been used to retract the jacks, the system
with all four red WARNING lights out prior to traveling.
reinitiated and the jacks should be completely retracted
starting a store procedure the store procedure should be
IMPORTANT: If power to the system is interrupted after
thermal expansion.
will automatically retract any jack that extends due to
the "WARNING" lights condition.
to store for fifty minutes, then shut down regardless of
"WARNING light does not go out, the system will continue
individual red "WARNING" lights are out. If any one red
will automatically shut down 1 minute after the four
retracts, its red WARNING light will go out. The system
before the rear jacks will begin to retract. As each jack
light will flash. The front jacks will retract for 5 seconds
press the "AUTO STORE" button. The store indicator
a jack to extend slightly. When the "AUTO STORE"
NOTE: When traveling thermal expansion may cause
"CANCEL" button on the HWH touch panel will stop
pushing the "AUTO LEVEL", "AUTO STORE" or the
IMPORTANT: During the Automatic Store procedures,
the automatic store function.
before traveling.
If jacks cannot be retracted by the above procedure see the
MANUAL JACK RETRACTION section.
