12MAY99
OPERATING PROCEDURES
MP35.455C
ROOM EXTENSION AND GENERATOR SLIDE EXTEND PROCEDURE
CAUTION:
OPERATING THE ROOM OR GENER-
ATOR SLIDE WITH ANY ROOM-LOCKING DEVICES LOCK-
ED OR THE MANUAL-RETRACT WINCH ATTACHED CAN
CAUSE PERSONAL INJURY AND VEHICLE DAMAGE. IT
IS THE OPERATOR’S RESPONSIBILITY TO ENSURE THAT
ALL ROOM-LOCKING DEVICES AND THE MANUAL-RETRACT
WINCH ARE DISENGAGED BEFORE OPERATING THE ROOM.
1. Remove any locking devices from the room extension or
generator slide.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF THE ROOM EXTENSION OR GENERATOR SLIDE.
NOTE: Make sure there is adequate clearance to fully extend
the room extension or generator slide.
2. Turn the ignition switch to "ACCESSORY"
NOTE: To operate the room extension or generator slide the
ignition key must be in the "ON" or "ACC" position. The level-
ing system does not have to be on and the vehicle does not
have to be level. The park brake must be set.
ROOM EXTENSION AND GENERATOR SLIDE RETRACT PROCEDURE
3. Push the ROOM EXTENSION or GENERATOR SLIDE
MASTER SWITCH to the "ON" position. Refer to the CON-
TROL IDENTIFICATION page.
4. To extend the room extension or generator slide, press and
hold the ROOM EXTENSION or GENERATOR SLIDE CON-
TROL SWITCH in the "EXTEND" position. When the room ex-
tension or generator slide is fully extended, release the CON-
TROL SWITCH.
IMPORTANT: Do not hold the CONTROL SWITCH in the "EX-
TEND" position for more than ten seconds after the room ex-
tension or generator slide is fully extended or stops moving.
IF EITHER SIDE OF THE ROOM EXTENSION OR GENER-
ATOR SLIDE STOPS MOVING, RELEASE THE CONTROL
SWITCH IMMEDIATELY.
NOTE: Releasing the CONTROL SWITCH will halt the oper-
ation of the room extension or generator slide.
5. Push the ROOM EXTENSION OR GENERATOR SLIDE
MASTER SWITCH to the "OFF" position.
6. Turn off the ignition switch.
CLEAR OF THE ROOM EXTENSION OR GENERATOR SLIDE.
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
1. Turn the ignition switch to "ACCESSORY".
2. Push the ROOM EXTENSION or GENERATOR SLIDE
MASTER SWITCH to the "ON" position.
NOTE: To retract the room extension or generator slide the
ignition key must be in the "ON" or "ACC" position and the park
brake must be set.
3. to retract the room extension or generator slide press and
hold the CONTROL SWITCH in the "RETRACT" position. When
the room extension or generator slide is fully retracted, release
the CONTROL SWITCH.
IMPORTANT: Do not hold the ROOM EXTENSION or GEN-
ERATOR SLIDE CONTROL SWITCH in the "RETRACT" po-
sition for more than ten seconds after the room extension or
generator slide is fully retracted or stops moving. IF EITHER
SIDE OF THE ROOM EXTENSION OR GENERATOR SLIDE
STOPS MOVING, RELEASE THE CONTROL SWITCH IM-
MEDIATELY.
NOTE: Releasing the CONTROL SWITCH will halt the op-
eration of the room extension or generator slide.
4. Push the ROOM EXTENSION or GENERATOR SLIDE
MASTER SWITCH to the "OFF" position.
5. Turn the ignition switch off.
6. If the room extension or generator slide will not retract see
the MANUAL ROOM RETRACT PROCEDURE.
IMPORTANT: Room-locking devices should be locked while
traveling.
