![HWH 210 SERIES Скачать руководство пользователя страница 7](http://html1.mh-extra.com/html/hwh/210-series/210-series_operators-manual_2190602007.webp)
The following is a list of problems, and possible solutions, which might occur to the leveling system.
NOTE:
vehicle’s suspension and electrical systems as well as an understanding of the leveling system’s hydraulic and electronics is
required.
TROUBLE SHOOTING
MP55.0
20DEC02
Only qualified technicians should install or repair leveling systems on vehicles. A knowledge of hydraulics, welding, the
1.
2.
3.
4.
5.
6.
7.
8.
JACK RETRACTS AFTER COACH IS LEVEL.
A.
B.
A.
B.
C.
D.
E.
A.
B.
C.
D.
A.
B.
C.
JACKS WILL NOT RETRACT COMPLETELY.
IGNITION SWITCH IS ON, BUT NO POWER TO PUMP
PUMP WILL NOT ACTIVATE.
Hose or jack has external leak.
Fluid is leaking back to reservoir through the control
Jack clogged with mud or ice.
Main rod bent or scored.
Valve plunger is not completely depressed by valve
Spring weak or broken.
Hydraulic line pinched.
Park brake not set.
12 volts from power source not present.
Faulty PC board.
Faulty wire or electrical connection.
Grounding switch on valve not working.
Pump relay not functioning.
Pump not grounded.
valve.
handle.
AND/OR LIGHTS.
HYDRAULIC PUMP ACTIVATES WITHOUT USE OF
A.
B.
C.
HYDRAULIC PUMP ACTIVATES, BUT THE JACKS
A.
B.
C.
D.
LEVELING LIGHTS (YELLOW) ARE NOT FUNCTIONING
A.
B.
WARNING LIGHTS (RED) ARE NOT FUNCTIONING
A.
B.
C.
CONTROL VALVE HANDLES.
WILL NOT EXTEND.
PROPERLY.
PROPERLY.
Grounding switch at valve shorted.
Pump relay stuck.
Relay control wire shorted to ground.
Store levers not in the operate position.
Oil supply is low in reservoir.
Pump is not developing pressure.
Broken hydraulic line.
Yellow lights will not go out when vehicle is level: ad-
If two or more yellow lights are on replace PC board
Light will not come on: check for broken wire at
Lights will not go out: bad warning switch or wires
Check PC board.
just sensing unit.
or check level sensing unit.
warning switch on the jack.
are shorted to ground.
Thermal contraction of fluid, jacks not lifting enough
Bezel plate not installed properly - interferes with
D.
C.
when stabilizing the vehicle.
STORE levers.
210/225 SERIES BI-AXIS VALVE