HWAM Classic 7H, Руководство пользователя

Страница: 25 / 40

25
The chimney must have a minimum opening equivalent to Ø 150 mm. The chimney opening should always
be at least the size of the outlet socket of the stove. The chimney must have an easily accessible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for
more information.
Fitting the loose parts
Before the stove is installed, you must ensure that all loose parts are fitted correctly.
Verticalcross-section of the stoves (drawing B)
1. Smoke shelf. Fits on top of side panels and should always be pushed right back against the back panel.
2. Baffle plate. Should always be fitted.
3. Ember/log guard. Place this inside the door.
4. Heat guard. Should always be in place.
5. Smoke shelf support. The front edge of the smoke shelf is protected by a U-shaped rail which should
always be in place (only Skamolex shelves).
6. In order to dismount the smoke shelf, it will first be necessary to dismount one side panel. Lift up
the smoke shelf and pull the edge of the side panel which is furthest away from you towards the
middle, until it freely passes smoke shelf support at front edge.
Connection to chimney
HWAM 7H has both rear and top smoke outlet that can be connected to an approved steel chimney on
top or directly out at the rear to a brick chimney.
Vertical cross-section of smoke flue (drawing C)
C1: Top smoke outlet
C2: Rear smoke outlet
1. Steel chimney.
2. Flue gas elbow. Fits into smoke flue socket.
3. Brick-built jamb of flue.
4. Built-in pipe sleeve. Fits smoke flue.
5. Wall rosette. Covers disruption to wall around pipe sleeve.
6. Joint. Sealed with packing material.
7. Smoke flues of the stove.
8. Cover for back outlet/hotplate for top outlet.
9. Isulation. 2.5 cm thickness.
10. Inside cover.
11. Fitting bolt.
12. Smoke flue regulating damper.
13. Soot door.
14. Smoke pipe for rear outlet (remove cover and inner cover plate).
Chimney
The chimney is the “engine” of the stove and it is crucial for the functioning of the woodburning stove.
The chimney draft provides a partial vacuum in the stove. This vacuum removes the smoke from the stove,
sucks air through the dampers for the so-called glass pane rinse which keeps the glass free of soot, and
sucks in air through both primary and secondary dampers for the combustion.
The chimney draft is created by the differences in temperature inside and outside the chimney. The higher
the temperature within the chimney, the greater the draft. It is crucial, therefore, that the chimney is
warmed up properly before closing the damper and limiting the combustion in the stove (a brick chimney
takes longer to warm up than a steel chimney). On days where the weather and wind conditions create
insufficient draught inside the chimney, it is even more important to warm up the chimney as quickly as
possible. The trick is to quickly get some flames going. Split the wood into extra fine pieces, use an extra
firelighter, etc.