background image

ã

2005 Hutchinson/Mayrath  All Rights Reserved

Clay Center, KS.  Printed in the USA

7–05

Part No. 1028533

INSTALLATION INSTRUCTIONS

This safety symbol is used throughout these instructions to alert you to information about unsafe actions or
situations, and will be followed by the word 

DANGER, WARNING, or CAUTION.

  Be Alert! Your safety and the

safety of others is involved.

DANGER – indicates immediate hazards that may result in severe injury or death.  WARNING – indicates unsafe actions
or situations that may cause severe injury, death and/or major equipment or property damage.  CAUTION – indicates unsafe
actions or situations that may cause injury, and/or minor equipment or property damage.

!

The following instructions are to be used for assistance with the set–up and installation of equipment, accessories,
and serviceable parts used on this vehicle and are not meant to replace any operating or safety procedures as outlined
in the Operators Manual.

Hutchinson/Mayrath

Gas Power Auger Drive Mount Kit,

Part No. A8254A

Install Fuel Tank

1. Mount the fuel tank support

 (Part No. 1028500)

 to the

mounting tabs located on the engine support plate

 as

shown in 

Figure 1

 (the support bracket will mount to

the outside of each mount tab). Secure using the

5/16–18 x 3/4” 

screws and

 5/16–18

 nylock nuts

provided in the kit.

2. Position the fuel tank onto the support bracket and

secure the tank to the bracket using the tie down
strap, 

Part No. 1028539,

 provided

 (See Fig. 1).

Fuel Line Connection

Mount Fuel Tank

Support Bracket

Tie Down

Strap

Figure 1

Install Fuel Tank & Support Bracket

3. Locate the fuel line assembly 

(Part No. 1028532) 

from

the kit.  Connect the end of the fuel line to the quick
connect fitting located on top of the fuel tank as shown
in Figure 1.

4. Attach the other end of the fuel line assembly to the

existing connector on the engine 

(See Fig. 2).

  Make

sure all hardware is tight and all hose clamps are
properly located.

Fuel Line Assembly

From Fuel Tank

Attach Fuel Line

to Existing Connector

on Engine

Figure 2

Connect Fuel Line to Engine

Отзывы: