Rev. 0309
5
LOCATION
The refrigerated merchandisers have been designed for
use only in air conditioned stores where temperature
and humidity are maintained at or below 75°F and 55%
relative humidity. DO NOT allow air conditioning,
electric fans, ovens, open doors or windows (etc.) to
create air currents around the merchandiser, as this will
impair its correct operation.
Product temperature should always be maintained at a
constant and proper temperature. This means that from
the time the product is received, through storage,
preparation and display, the temperature of the product
must be controlled to maximize life of the product.
UNCRATING THE STAND
Place the fixture as close to its permanent position as
possible. Remove the top of the crate. Detach the walls
from each other and remove from the skid. Unbolt the
case from the skid. The fixture can now be lifted off the
crate skid. Lift only at base of stand!
EXTERIOR LOADING
These models have not been structurally designed to
support excessive external loading. Do not walk on
their tops; This could cause serious personal injury and
damage to the fixture.
DANGER!
SETTING AND JOINING
The sectional construction of these models enable them
to be joined in line to give the effect of one continuous
display. A joint trim kit is supplied with each joint.
LEVELING
IMPORTANT! It is imperative that cases be leveled
from front to back and side to side prior to joining. A
level case is necessary to insure proper operation,
water drainage, glass alignment, and operation of the
hinges supporting the glass. Leveling the case cor-
rectly will solve most hinge operation problems.
NOTE: A. To avoid removing concrete flooring, begin lineup
leveling from the highest point of the store floor.
B. When wedges are involved in a lineup, set them first.
All cases were leveled and joined prior to shipment to
insure the closest possible fit when cases are joined in
the field. When joining, use a carpenter’s level and shim
legs accordingly. Case must be raised correctly, under
legs where support is best, to prevent damage to case.
Merchandisers must be installed level to ensure proper
operation of self closing doors. Place prybar under base
Installation
and lift. DO NOT LIFT END PANEL. Turn leveler,
with 5mm allen wrench, clockwise to raise, counter
clockwise to lower. Repeat process with other levelers
until case is level.
NOTE: To avoid removing concrete flooring, begin
lineup leveling from the highest point of the store.
1. Check level of floor where cases are to be set.
Determine the highest point of the floor; cases will
be set off this point.
2. Set first case, and adjust legs over the highest part
of the floor so that case is level. Prevent damage –
case must be raised under leg or by use of 2x6 or
2x4 leg brace. Remove side and back leg braces
after case is set.
3. Set second case as close as possible to the first case,
and level case to the first using the instructions in
step one.
4. Apply masking tape 1/8" in from end of case on
inside and outside rear wall on both cases to be
joined.
5. Apply liberal bead of case joint sealant (butyl) to
rear adjoining wall of first case.
DO NOT USE PERMAGUM!
It is the contractor's
responsibility to install
case(s) according to local
construction and health
codes.
6. Slide second case up to first case snugly. Then level
second case to the first case so deck, bumper and
top are flush.
7. To compress silicone at joint, use two Jurgenson
wood clamps. Make sure case is level from front to
back and side to side on inside bulkheads at joint.
8. Attach sections together via a 3 bolts located in the
