iGFC-Cr3H-HtB-0508
8
Case Startup
Controls
The controls are located at the rear of the case.
Control Panel
Locaton
Timer Panel
Locaton
Parts of the case exterior, shelves and
light bulbs become extremely hot when
in use.
USE EXTREME CAUTION!
FRONT GRIDDLE
INITIAL
SETTING
"4"
REAR GRIDDLE
INITIAL
SETTING
"4"
LIGHTS and GRIDDLE ON / OFF
TURN
SWITCHES
ON
Check to make sure all lights come on
at start-up.
If they do not contact your Service
Department
Control Panel on Rear of Case
Number of controls may vary.
POWER
ON / OFF
430-01-0365 9810
1
2
3
4
5
6
7
8
9
10
Sta
r tu
p
430-01-0365 9810
1
2
3
4
5
6
7
8
9
10
Sta
r tu
p
temperature adjustment
allow case preheat for 45 minutes prior to loading.
note: this equipment is not designed to heat-up or cook food.
Food should be slightly higher temperature than
desired holding temperature when put in display.
1.
Measure proDuCt temperature hourly
by
inserting a food thermometer into the food. Proper
holding temperature is 135ºF.
. To change temperature, increase or decrease
Overhead Heat by one number at a time. Adjust
the griddle temperature as necessary. Measure
product temperature again in one hour. Re-adjust if
necessary.
timer operation
Numbered product
keys above
correspond to
FC4H-Cinnabon
pans 1-7 below
(back of case)
1
2
6
7
3
5
4
1
2
3
4
Numbered product
keys above
correspond to
FC3H-Cinnabon
pans 1-4 below
(back of case)
©FAST key
NOTE: The colon will flash if the unit is in hours / minutes mode
and be on constant in minutes / seconds mode.
• To enter programming from ‘--:--’, press the
©(FAST.) key for three seconds. The display will
change to “PROG”.
