Hussmann IMPACT D5ELE, Подключение

Страница: 7 / 7

13
Refer to Poster 389043 or
I/O manual or to remove and
install top rail and bumpers.
Install upper bumper and bumper
trim on end of case both sides.
Push into place. Slide internal
bumper trim under end of upper
bumper. Install full length
bumpers and trim flush and offset
across joints, making sure no gaps
exist between sections. Push into
place.
Install lower bumper on end case
both sides. Push into place. Add
full length bumpers flush with
bumper and offset across joints,
making sure no gaps exist
between sections. Push into place.
Install top rail on end case both
sides; push front down over color
panel until snap, then push rear
over light channel until snap.
Add full length top rail flush and
offset across joint.
R
EFRIGERATE CASE LINEUP AND
LAST SECTIONS FOR AT LEAST
6
HOURS
.
Before installing last sections, tap the
right end of top rail and bumpers to
close any gaps. Measure between
right end and installed rail or bumper.
Use a miter box and fine-toothed saw
to cut last bumpers to length.
Before installing last section of upper
bumper, install internal trim flush to
right end, then install cut bumper.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
7
P/N 407199
D5ELE/D5EE END CASES TO D5 PARENT CASE
JOINING INSTRUCTION
Fig. 10. Installing Bumpers and Top Rails
Top Rail
Bumpers