Husqvarna Z 246, Руководство оператора

Страница: 22 / 60

Refer to Lubrication Interval
Yearly Each 25
hours
Each 50
hours
Each 200
hours
C Lubricate the grease nipple with a grease gun. X
D Do a check of the oil level. X
E Replace the oil filter. X
Always use good quality grease. Always use
recommended oil, refer to
Technical data on page
26 .
To lubricate the front wheels
• Grease the nipple (A) with a grease gun until
grease comes out from the top washer.
A
B
• Lubricate the joint bearing of the front wheels (B)
with a grease gun until grease comes out.
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
Troubleshooting
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem Cause
Engine does not start. The drive of the blades is engaged. Refer to
PTO (Power Take-
Off) button on page 4
.
The control levers are not locked in the outer position.
The battery is too weak. Refer to
To charge the battery on page
17
.
There is dirt in the carburetor or the fuel line.
The fuel shut-off valve is closed or in the incorrect position.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
22 1550 - 002 - 08.12.2022