Husqvarna W 250 P, Руководство оператора

Страница: 9 / 56

To clean the product
WARNING: Make sure that the motor switch
and the pump switch are in the Off positions,
before cleaning the product. Disconnect the
power cord. Do not remove the pump cable
It is important to clean the product to prevent damage
and circulation of dangerous waste. Always clean the
product before it is moved from the work area. If the
product has to be used for other purposes, it is
extremely important that the product will be cleaned, to
avoid spreading of hazardous material.
After running slurry through the pump, flush the system
with significant amount of fresh water. Do not leave
slurry in the pump or bottom of the tank. This will cause
damage to the pump and the slurry will harden and clog
the system. When using the unit dry and then switching
to wet, or vise a versa, make sure the filters are cleaned
properly and throughly to not have build up or clogging
in the system.
All parts that are contaminated after service work must
be disposed in a correct procedure in plastic bags. Refer
to local regulations.
• Use correct personal equipment when you clean the
product. Refer to
Personal protective equipment on
page 6
• Clean the external surface with a moist cloth.
• Clean the filters and the slurry collector in applicable
area.
• Flush the system with fresh water to throughly clean
the pump.
Filter change
WARNING: Use personal safety equipment,
refer to
Personal protective equipment on
page 6
, during filter change. Dust can come
out during filter change.
WARNING: Always turn the motor switch in
the Off position and disconnect the cord
from the wall outlet during filter change.
To replace filters
Only W 70 and W 70 P have an extra filter to slurry foam
from particles.
1. Disconnect the power cord. Remove the pump
cable.
2. Loosen the 3 toggle fasteners to remove the top.
3. Lift off the filter holder with the filter.
4. Loosen the nut on the filter holder and remove the
filter cap and the filter.
5. Do a check of the gasket on the filter holder.
Replace the gasket if it is damaged.
6. Assemble the new filter.
7. Clean all other parts.
Floating device
A floating device protect the motor from liquid.
• Visually inspect the floating device regularly to
ensure that it is not damaged and free of
obstructions.
When the floating device is being activated, the motor
needs to be switch off and water has to be evacuated
before the motor is turned on.
Troubleshooting
Troubleshooting schedule
Issue Cause Solution
Motor does not start
No power Connect the product
Cable defective Replace the cable
Switch defective Replace the switch
Motor stops immediately after
starting
Wrong fuse Connect to correct fuse
Shortcut in cable/machine Order service
1056 - 002 - 02.04.2019 9