Husqvarna Viking Designer Sapphire 85, Руководство пользователя

Страница: 29 / 50

Changing the Needle
1. Use the hole in the multipurpose tool to hold the needle.
2. Loosen the needle screw with the screwdriver.
3. Remove the needle.
4. Insert the new needle using the multipurpose tool. Push
the new needle upwards with the flat side away from you
until it will go no further.
5. Tighten the needle screw with the screwdriver.
Threading the Upper Thread
Make sure that the presser foot is raised and the needle is in
the up position.
Horizontal Spool Pin
1. Hold the thread near the spool using your right hand.
2. Use your left hand to bring the end of the thread over
and behind the Pre-Tension Thread guide (A) and under
the thread guide (B). Bring the thread between the thread
tension discs (C).
3. Continue threading in the direction indicated by the
arrows. Bring the thread from the right when threading
into the slot on the take-up lever (D).
4. Take the thread down into the last thread guide (E) just
above the needle.
C
D
E
A
B
2 Preparations 29