Husqvarna VIKING Designer EPIC, Руководство пользователя

Страница: 39 / 202

Bobbin Winding
All types of thread, including specialty threads such as
invisible or other stretchy threads, metallic or flat metallic
threads, should be wound directly from the auxiliary spool
pin without passing the needle and presser foot.
Note: Always wind specialty threads at lower speed.
1. Place a thread spool on the auxiliary spool pin.
Using both hands, pull the thread behind the right clip
on the telescopic thread guide (A). The thread should
run from right to left.
Note: When using large thread cones, place the large spool holder with
the flat side up and a cone holder on the auxiliary spool pin before
adding the thread cone.
2. Bring the thread through bobbin winding thread guide
(A) from back to front and to the right.
Bring the thread through bobbin winding thread guide
(B), around the thread tension disc (C) and down
through thread guide (D) as illustrated.
For some specialty threads, following the normal
threading path will result in a bobbin that is wound
too tight. If this happens, bypass thread guide (B) and
thread tension disc (C) to reduce the amount of tension
on the thread. Pull the thread from thread guide (A)
directly to thread guide (D) instead.
2 Preparations 39