Transport Latch
The transport latch will set the deck to the
transport height of 5" when the lift lever is pulled
back. The latch can also used to mow at the 5"
cutting height.
To release the deck left lever out of transport
mode, push the transport latch forward.
IMPORTANT INFORMATION
Always raise the
deck to the highest position for transport.
Fuel Tank
Read the safety instructions before refueling. The
capacity for the tank is 24.6 litres (6.5 gallons).
Regularly check the gas cap gasket for damage
and keep the cap properly tightened.
WARNING
! Fill to bottom of filler neck.
Do not overfill. Wipe off spilled oil or fuel. Do
not store, spill or use gasoline near an open
flame.
The engine will run on a minimum of 87-octane
unleaded gasoline (no oil mix). Environmentally
adapted alkylate gasoline can be used. See the
Technical Data
section in this manual concerning
ethanol fuel. Methanol fuel is not allowed. Do
not use E85 alcohol based fuel. Damage to the
engine and components may occur.
When operating in temperatures below 0°C
(32°F), use fresh, clean winter grade gasoline to
help insure good cold weather starting.
IMPORTANT INFORMATION
Experience
indicates that alcohol blended fuels (called
gasohol, ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic gas
can damage the fuel system of an engine while
in storage. To avoid engine problems, the fuel
system must be emptied before storage of 30
days or longer. Drain the gas tank, start the
engine and let it run until the fuel lines and
carburetor are empty. Use fresh fuel the next
season. See
Storage
for more information. Do
not use engine or carburetor cleaners in the
fuel tank or permanent damage may occur.
WARNING!
The engine and the exhaust
system, become very hot during operation.
There is a risk for burns if touched. Let engine
and exhaust system to cool before refueling.
WARNING
! Gasoline is highly flammable.
Observe caution and fill the tank outdoors.
Park Brake
The park brake is found on the right side of the
control console. Pull the lever back to engage the
brake and push forward to release it.
IMPORTANT INFORMATION
The machine
must stand still when engaging the park brake.
Release the park brake before moving the
mower.
14
CONTROLS
Содержание V554
Страница 41: ...41 SERVICE JOURNAL ...
Страница 42: ......
Страница 43: ......
Страница 44: ...2018 05 01 ...