Husqvarna TS 400 F, Руководство оператора

Страница: 18 / 78

START-UP
Use
•
Utilization: sawing marble, stone, granite, brick,
cement and any covering material such as
sandstone, earthenware, ceramics, etc.)
•
Tools: Ø 900mm or 1000mm water diamond discs
with 60mm bore.
(For further information, see supplier)
It is strictly forbidden to use the saw
for any purpose other than that for
which it has been designed.
Handling - Transport
•
The two wheels (3) [FIG. 1] at the front of the
machine pivot with the locking system.
•
Use the four slinging rings (17) [FIG.1] on the struts.
•
Sleeves (21) [FIG.1] allow the machine to be moved
with a forklift.
For transport, lock the head as follows:
•
Position the cutting head at the level for locking the
transport screws (A)
•
Using wrench (B), tighten the screws (A) until the casters
are no longer n contact with the guide bars [FIG.2]
[FIG.2]
•
Slide the wrench (B) into the slot provided [FIG.2].
To start using the machine, follow the transport
procedure in reverse order.
Installing the disc
Unplug the machine form the electrical
power supply.
•
Disconnect water supply tube (F) [FIG.3]
•
Remove disc housing cover (15) [FIG.1]
•
Loosen tightening nut (E) [FIG.3] with wrench provided
•
Remove tightening flange (C)
•
Place disc on centering flange (D).
[FIG.3]
Rotate in the direction shown by the
arrow on one of the sides.
Make sure that the bearing surfaces of
the disk, flanges and shaft are clean.
•
Put back the tightening flange (C),
•
Tighten nut (E),
•
Put back and fasten disk cover
•
Reconnect the water supply tube (F).
For your safety and that of others,
make sure that all guards are back in
place before using.
Start
Danger : risk of cuts
Always remain attentive
8 - English
No wood or metal
saw blade!
No carbon disc!
A
E
C
D
B
F