Husqvarna TE 250, Руководство пользователя

Страница: 90 / 169

13 BRAKE SYSTEM
88
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
Preparatory work
–
Check the front brake linings. ( p. 88)
S04460-10
Main work
–
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
–
Remove screws
1
.
–
Take off cover
2
with membrane
3
.
–
Add brake fluid to level
A
.
Guideline
Level
A
(brake fluid level
below reservoir rim)
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 155)
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
13.5 Checking the front brake linings
Warning
Danger of accidents Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized Husqvarna Motorcy-
cles workshop will be glad to help.)
S04461-10
–
Check the brake linings for minimum thickness
A
.
Minimum thickness
A
≥
1 mm (
≥
0.04 in)
» If the minimum thickness is less than specified:
–
Change the brake linings of the front brake.
( p. 89)
–
Check the brake linings for damage and cracking.
» If damage or wear is encountered:
–
Change the brake linings of the front brake.
( p. 89)