Husqvarna TE 150, Руководство пользователя

Страница: 111 / 162

15 ELECTRICAL SYSTEM
109
15.7 Changing the headlight bulb
Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
Preparatory work
–
Remove the headlight mask with the headlight. ( p. 107)
V01003-10
Main work
–
Turn protection cap
1
together with the underlying bulb
socket counterclockwise all the way and remove it.
–
Pull bulb socket
2
of the parking light out of the reflector.
F00361-10
–
Pull out headlight bulb
3
.
–
Insert the new headlight bulb.
Headlight (HS1/socket BX43t) ( p. 146)
–
Insert the protection cap with the bulb socket into the reflec-
tor and turn it clockwise all the way.
O-ring
4
is correctly positioned.
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. ( p. 108)
–
Check the headlight setting. ( p. 109)
15.8 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the
wall.
Guideline
Distance
A 5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.