Husqvarna TC 85, Руководство пользователя

Страница: 42 / 131

10 TUNING THE CHASSIS
40
402659-10
Main work
–
Measure the full spring length while it is under tension and
note down the value.
–
Loosen screw
1
.
–
Turn adjusting ring
2
until the spring is no longer under ten-
sion.
Holding wrench (90129051000)
–
Measure the overall spring length while the spring is not
under tension.
–
Tighten the spring by turning adjusting ring
2
to measure-
ment
A
.
Guideline
Spring preload 11 mm (0.43 in)
Info
The spring preload is the difference between the
relaxed spring length and the tensioned spring length.
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
Tighten screw
1
.
Finishing work
–
Install the shock absorber. ( p. 54)
–
Remove the motorcycle from the lift stand. ( p. 45)
10.11 Adjusting the riding sag
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 45)
–
Remove the shock absorber. ( p. 54)
–
After removing the shock absorber, clean it thoroughly.
B00292-10
Main work
–
Choose and mount a suitable spring.
Guideline
Spring rate
Weight of rider:
≤
45 kg
(
≤
99 lb.)
35 N/mm (200 lb/in)
Weight of rider: 45 …
55 kg (99 … 121 lb.) 40 N/mm (228 lb/in)
Weight of rider:
≥
55 kg
(
≥
121 lb.)
45 N/mm (257 lb/in)
Info
The spring rate is shown on the outside of the spring.
Smaller weight differences can be compensated by
changing the spring preload.
Finishing work
–
Install the shock absorber. ( p. 54)
–
Remove the motorcycle from the lift stand. ( p. 45)