Husqvarna TC 125 2017, Руководство пользователя

Страница: 113 / 138

20 TROUBLESHOOTING
111
Faults Possible cause Action
Engine stalls or is popping into the
carburetor
Lack of fuel (All TC models)
–
Turn handle  of the fuel tap to the ON
position. (Figure F00230-10 p. 16)
(TX 300)
–
Turn handle

of the fuel tap to the
ON
position. (Figure F00231-10 p. 16)
(TX 300)
–
Turn handle

of the fuel tap to the RES
position. (Figure F00231-10 p. 16)
–
Refuel. ( p. 29)
Engine takes in bad air
–
Check the intake flange and carburetor for
tightness.
The connector or ignition coil is
loose or oxidized
–
Clean the connector and treat it with contact
spray.
Engine overheats Too little coolant in cooling system
–
Check the cooling system for leakage.
–
Check the coolant level. ( p. 92)
Too little air stream
–
Switch off engine when stationary.
Radiator fins very dirty
–
Clean the radiator fins.
Foam formation in cooling system
–
Drain the coolant. ( p. 93)
–
Refill with coolant. ( p. 93)
Damaged cylinder head or cylinder
head gasket
–
Check the cylinder head and cylinder head
gasket.
Bent radiator hose
–
Change the radiator hose.
Incorrect ignition point due to loose
stator
–
Adjust the ignition.
White smoke emission (steam in
exhaust gas)
Damaged cylinder head or cylinder
head gasket
–
Check the cylinder head and cylinder head
gasket.
Gear oil exits at the vent hose Too much gear oil added
–
Check the gear oil level. ( p. 105)
Water in the gear oil Damaged shaft seal ring or water
pump
–
Check the shaft seal ring and water pump.